Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R6415 Installation and Service Manual

PDF

Installing the power interposer board

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Align the slots on the PIB with the standoffs on the system and slide the PIB into place.
  2. Using Phillips #2 screwdriver, tighten the two screws to secure the PIB to the system.
  3. Route the cables and connect them to the system board and backplane.
    Figure 1. Installing the power interposer board This images shows installing the PIB

Next steps

  1. Install the PSUs. For more information, see Installing a hot swappable power supply unit .
  2. Install the air shroud. For more information, see Installing the air shroud .
  3. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\